The course

Chapter 18

Jeans

Every number below follows the size you pick.

Jeans are trousers with a yoke across the back, five pockets and a fly with a zip, sewn in a heavy woven fabric.

The trousers chapter shows the frame, the crotch curve and the legs. Jeans start from that trouser base without darts; the back is shaped by a yoke instead.

What you need

MeasurementWhere the tape goesSize 50
WaistRound the natural waist, where the body is narrowest, usually just above the navel.88.0 cm
SeatRound the fullest part of the seat, feet together.102.0 cm
Outside legDown the side of the leg from the waist to the floor, without shoes.105.5 cm
Body riseSeated on a firm, flat chair: from the waist at the side straight down to the seat of the chair.27.0 cm
Waist to hipDown the side of the body from the waist to the fullest part of the hip or seat.21.0 cm

Draft the jeans to your measurementsFree to draft, your first PDF free

Front.
Back.

How it is drafted

  • Back yoke. The top of the back leg is cut off as a yoke, deeper at the centre back than at the side, which shapes the back over the seat.
  • Front pockets. The pocket opening is cut out of the front; a facing and two pocket bags fill it.
  • Fly. A fly extension on the front and a fly shield carry the zip.
  • Waistband and loops. A straight waistband and a strip cut into belt loops finish the top.

The finished pieces

FRONTBACKBACK YOKEPOCKET FACINGPOCKET BAG, SMALLPOCKET BAG, LARGEBACK POCKETWAISTBAND
Jeans, size 50. Front (2×), Back (2×), Back yoke (2×), Pocket facing (2×), Pocket bag, small (2× lining), Pocket bag, large (2× lining), Back pocket (2×), Coin pocket (1×), Waistband (1×), Belt loop strip (1×), Fly shield (1× (fold lengthwise)). Seam allowance is added afterwards.

Sewing it

  1. Cut and mark. Cut the denim with the grain along the selvedge, the bags from pocketing. Mark the fly, the facing line on the large bags, the back pocket positions and the notches.
  2. Set up. A jeans needle (100) and topstitching thread in the needle; regular thread in the bobbin. Flat-felled or overlocked seams.
  3. Front pockets. Sew the coin pocket to the right pocket facing. Neaten the curved edge of each facing and topstitch it onto a large bag along the facing line. Sew a small bag to the pocket opening of each front, turn it in, understitch and topstitch twice. Lay the large bag with its facing under the opening, matching the waist and the side, and sew the two bags together round the bottom. Baste the top and the side.
  4. Fly zip. Sew the crotch seam of the fronts up to the fly notch. Fold the right fly extension under on the centre front and sew the zip to it; lay the left front over to the centre front, sew the zip to the left extension and topstitch the J line. Sew the folded fly shield under the right side.
  5. Back yoke. Sew the yoke to each back, matching the notches, flat-fell the seam towards the waist and topstitch twice.
  6. Back pockets. Hem the pocket tops, press the edges under and topstitch the pockets onto the marked positions, with bar tacks at the top corners.
  7. Centre back. Sew the centre back seam through the yokes and flat-fell it.
  8. Inseams and side seams. Flat-fell the inseams, then sew the side seams through the pocket facing and bags, overlock them and topstitch towards the back down to the hip.
  9. Waistband. Make the belt loops from the strip. Sew the waistband to the waist, fold it over, close the ends and topstitch all round, catching the loops at the waist.
  10. Hem and finish. Turn the leg hems up twice and topstitch. Make the buttonhole, set the jeans button and add rivets or bar tacks at the pocket corners.
Make it

Draft the jeans to your measurements

The editor draws this pattern for your body in a few seconds, with seam allowance, notches and sewing steps. Your first PDF is free.

Open the jeans
New chapters

Get new patterns and chapters by e-mail

About once a month. We send a link to confirm, which also opens a free account.