How to take body measurements for sewing
Where the tape goes, how tight it should be and which mistakes make a pattern fit badly. Ten minutes, a tape measure and someone to help.
A pattern drafted to your body is only as good as the numbers it starts from. Measure slowly, write each number down at once, and measure twice when in doubt.
Before you start
- Wear light, close-fitting clothes or underwear. A thick jumper adds centimetres everywhere.
- Let someone else measure you. Measuring yourself bends the body and the numbers come out wrong.
- Stand naturally, feet slightly apart, looking ahead. For the seat, put the feet together. Do not breathe in or stand taller than usual.
- Tie a string round the middle and move a little until it settles at the natural waist. Many lengths start or end there, and the string keeps it in one place.
How tight
Round the body, the tape is snug but does not pull in: a finger should slide under it. It stays level, parallel to the floor, all round. Check in a mirror. Do not add room yourself: the ease, the extra width a garment needs to be worn, is added in the draft.
The measurements most patterns need
- Chest or bust: round the fullest part, under the arms and across the shoulder blades. For women's patterns, in the bra the garment will be worn with.
- Waist: round the natural waist, where the body is narrowest, usually just above the navel.
- Seat or hip: round the fullest part, feet together.
- Neck: round the base of the neck, over the bone at the back and just above the collarbones.
- Nape to waist: down the centre back, from the bone at the base of the neck to the waist string.
- Arm length: from the shoulder point over a slightly bent elbow to the wrist bone.
- Body rise for trousers: seated on a firm, flat chair, from the waist at the side straight down to the seat of the chair.
- Outside leg: down the side of the leg from the waist to the floor, without shoes.
Lengths are taken along the body, not through the air: the tape follows the curve.
Check the numbers
Some measurements must agree with others. Nape to waist is always longer than the depth to the armpits; across the back is shorter than shoulder to shoulder. The editor checks these and warns you before you print, and every measurement in it shows on a figure where the tape goes.